Home » Developer & Programmer » Forms » How to give a report a parameter, and how to accept it?
How to give a report a parameter, and how to accept it? [message #144436] Wed, 26 October 2005 07:52 Go to next message
adamjsawyer
Messages: 79
Registered: April 2005
Location: Perth, Western Australia ...
Member
I need to run a report from a form, supplying it with a parameter to limit the data that comes out to just one invoice. I have been told there are two ways:
1) Use a global variable
2) Use a report parameter
I have had a look at report paramters but can't figure out how to use a custom one (all I saw were parameters for say, DES_FILENAME etc)

Can anyone advise me on which method to use, and maybe point me to a message that explains how to do it? I tried searching the forums but can't seem to get the right key words

thx
adam

Report message to a moderator

Re: How to give a report a parameter, and how to accept it? [message #144458 is a reply to message #144436] Wed, 26 October 2005 10:13 Go to previous message
saadatahmad
Messages: 452
Registered: March 2005
Location: Germany/Paderborn
Senior Member
hi,
If you read this thread, you can find your answer of how to pass parameters from for to report.
http://www.orafaq.com/forum/t/52330/67693/

Redards

Report message to a moderator

Previous Topic: form navigation.
Next Topic: form runtime
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri Sep 20 02:24:47 CDT 2024
.:: Forum Home :: Blogger Home :: Wiki Home :: Contact :: Privacy ::.